Get this great custom made wooden floor kit, guaranteed to fit perfectly in your new Trade Tested shed. Manufactured locally and made from FSC Certified New Zealand Pine, this great kit comes with everything you’ll need to create the perfect foundation and floor for your awesome new shed.
Get this great custom made wooden floor kit, guaranteed to fit perfectly in your new Trade Tested shed. Manufactured locally and made from FSC Certified New Zealand Pine, this great kit comes with everything you’ll need to create the perfect foundation and floor for your awesome new shed.
The floor is rebated to prevent any moisture damage and all the timber has been treated - rough-sawn H4 bearers and rough-sawn H3.2 floorboards. The kit also contains galvanised nails.
All timber is cut to size and takes very little time to build.
FEATURES
• H4 Bearers (rough-sawn)
• H3.2 Floorboards (rough-sawn)
• Galvanised nails/nail plates
SPECIFICATIONS: GS508
Bearers: 1535mm x 75mm x 50mm (14)
Floorboards: 1318mm x 150mm x 19mm (40)
Nails: 60mm x 2.8mm (335)
Nail plates: 6T5 180mm x 34mm (14), 6T10 180mm x 68mm (7)
Our friendly and knowledgeable gurus are trained to answer all your questions as quickly as possible. So if there’s anything you need to know just give us a call during business hours, or send us an email any time.
Great base for the shed. Solid.
Did the job
If you're not putting down a concrete slab, this kit is a great time saver with everything pre-cut and ready to install. As with any construction, it's absolutely critical that you pay attention at this stage to getting to the ground nice and level for the bearers and ensuring that everything is perfectly square before laying the floorboards.
Easier than thought,
Like other reviewers, found, the finished floor was too small for the shed (50mm), not insurmountable, but frustrating when nearest hardware is 60km away. Otherwise assembly OK. Would recommend, with caveats on sizing.
This made installing the shed easier, But. I found it better to lay the floor boards after the shed was mounted to the bearers, though expect to have a gap to fill, I did, about 40mm, unless you put a gap between each board which I did not want to do.
The floor is not the size it is meant to be. Its too small. We will have to figure out a way to extend it. Not happy.
On completion of the floor, it did not fit the corresponding shed without improvisation on extending the floor.
The quality of the wood was quite poor. The floor was easy to put together
The timber floor is great. Comes cut to length with the required fixings to join the bearers together and to nail the boards in. If you are using this in combination with the Trade Tested shed of the same size, please be aware that the shed is slightly too large for this floor and the supplied fixings don't work. You will also want to leave the end floor boards off until you have the walls up, so that the corner brackets fit. That's not a flaw of this floor though.