This small stainless steel circulator pump is designed for boosting hot & cold water pressure in domestic properties. Boost hot & cold water circulation in domestic applications. Suitable for heating, ventilating and air conditioning HVAC circulation, pressure boosting of hot water in homes powered by solar energy, industrial auxiliary equipment, cold and hot water circulation.
This small stainless steel circulator pump is designed for boosting hot & cold water pressure in domestic properties. Boost hot & cold water circulation in domestic applications. Suitable for heating, ventilating and air conditioning HVAC circulation, pressure boosting of hot water in homes powered by solar energy, industrial auxiliary equipment, cold and hot water circulation.
Designed for open vented systems, it can also be installed directly on the incoming water mains supply to feed a combination boiler subject to local authority approval.
This integral flow switch design provides additional pressure to outlets where the required flow rate is up to 0.3 l/s. Operation is by three position switch, OFF, MANUAL and AUTO. In the AUTO mode the pump starts and stops using the integral flow switch (activated by a gravity flow of 2 l/min). The gravity flow at all fittings should be checked to ensure that the pump will operate when the outlet fitting is opened. When the MANUAL mode is selected the pump will run continuously.
Suitable for pumping clean, thin, non-aggressive liquids not containing solid particles or fibres (rain water, potable water, fresh water)
The pump should not be operated for long periods without flow through the pump. Minimal maintenance of the pump is required. Periodically the flow switch may need cleaning depending on operating conditions.
FEATURES
• Boost water pressure in domestic applications
• Flow switch for AUTO operation
• Adds 0.5 - 0.75 bar of pressure to the inlet pressure at the pump
• Quiet design
• 1.5 metre flying lead for connection to a 3A fused switched spur
• Suitable for pumping clean, thin, non-aggressive liquids not containing solid particles or fibres
• 2 Year Hyundai Warranty
To avoid cavitation noise and risk of damage to the pump bearings, a pressure of minimum inlet pressure of 1.5 m head (0.15 bar) is required at the pump during operation.
SPECIFICATIONS
Pump:
Automatic pressure boosting
Anti-rust cast iron pump body
Noryl impeller with heat resistance up to 150°C
99% alumina ceramic shaft
Liquid temperature: 2°C - 60°C
Inlet/outlet: 15mm
Pipe size: 1”
Max flow: 25 L/min
Max. head: 9m
Max. pressure: 12psi
Motor:
Insulation class: H
Protection class: IP42
99% alumina ceramic bearing
Copper winding
Dimensions: L 129mm x W 120mm x H 160mm
Does what it says on the wrapper.
Brilliant would totally recommend
No real addition to the pressure, auto function doesn't work. Must have got a dud
Installed 2 months ago, happy so far
I used this pump to boost the flow from the low pressure cylinder to the in home outlets, bathroom/kitchen/laundry. Total success. As advertised simple installation & very quiet & I am totally satisfied with the result. Facing the same circumstance as above I would recommend the Hyundai 123W to others. Note, if you lack the skills to install, consult the trades, plumber & electrician, highly recommended.
Product works well, plenty of power. do your research if boosting a low pressure shower system. put this in you'll likely need to also review your: tank capacity, header tank capacity, shower mixer setup. pump on its own is not the answer.
Purchased the Hyundai booster pump to solve very low hot water pressure in the bathroom. The home is older and has 1/2 inch pipework. Installation was easy with the aid of some premade flexible pipe fittings. The pump solved the pressure issue and is very quiet in operation. Would recommend this product.
Works really well
Ideal small pump for tank top up
Put this in yesterday, works great. Very quite.